Samsung Washing Machine Repair & Services in Bangalore
Samsung washing machines are considered to go for the long run. It is one of the most reputed brands in the market and people trust it for providing good quality products. Not only are they a great addition to any household, but they're reliable and easy to use. However, washing machines from reputed brands can also get faulty. But when something goes wrong with your washing machine, you first need to check the cause of the problem. Here's a guide to the commonly faced problems with the Samsung Washing Machine and how you can fix them.
1. The front-load washing machine has an issue with the door locking.
A safety feature called door locking prevents the doors from opening while the washing machine is in
use.
The most common challenge with front-load washing machines is that the door won't open even after
the machine is off. It is expected that the door shouldn't open while the wash cycle is running, but if it
does after the washer has stopped, you should check to see whether any water is still in the drum
because if there is any, the lock won't operate. Another possibility is that the door jammed due to a
defective, broken, or handled improperly interlock. Moreover, overheating could also be a primary
cause of the problem. So wait until the machine has completely cooled before checking to see if it
opens.
If it still doesn't open, it has likely malfunctioned, and you must seek professional help here.
2. The front-load washing machine is not spinning.
The lid switch assembly will prevent the washer from spinning when the lid is open. Check for the continuity of the lid switch by using a multimeter. If continuity fails, get it replaced. Another issue could arise from a loose or broken drive belt. Check it out, then either fix it or get a new one. Lastly, a damaged door latch can also stop your washer from spinning; make sure it is not damaged.
3. The front-load washer is not agitating.
The drive block connects the agitator and washer transmission. The transmission shaft will rotate if the
drive block is worn out, but the agitator will either move little or not. Check the drive block for
imperfections. Replace the drive block if it is damaged, stripped, or worn out.
Another factor could be that the washing door might not latch properly if the door lock is broken. Both
mechanical and electrical failures are possible with the door lock. Check for the damage and repair it.
4. Top-load washing machine is stopping mid-cycle
The water inlet valve opens to let the water enter the wash tub during the rinse cycle. The washing
machine will continue to wait for the water to enter it, even if the water intake valve malfunctions,
ultimately stopping the washer in the middle. Use a multimeter to check the continuity of the water
inlet valve to see whether it is broken. Replace the water inlet valve if it lacks continuity.
Also, there is a possibility that the main control board is broken. However, this problem is rarely caused
by the main control board. Check the most frequently defective parts first, then replace the main control
board if nothing works.
5. The fully automatic front-load washer is leaking water.
First, ensure the door is shut tightly and the seals are intact. The hose connections should come next. Make sure there is no damage, and they are tight. The location of the drain line within your drainage system also needs careful attention.
If all the solutions mentioned above seem a tedious task to do, then LetMeRepair has a Washing Machine Repair Service in Bangalore. Our highly trained technicians visit homes and offices and perform the necessary repairs on your machine so you can get back to your life as quickly as possible. LetMeRepair takes care of everything from the diagnosis to the repair process until your machine is back in action!
Visit our website for more details letmerepair.in.