washing machine repair in bangalore

Whirlpool Washing Machine Repair in Bangalore

Oct 17. Let Me Repair.

Whirlpool is a washing machine brand that has been around for over 100 years. They are known for their quality, reliability, and durability. They have a wide range of models to suit every need from the beginner to the professional user. It is a perfect appliance for your home. But sometimes, it gets damaged due to overuse or some other reasons.

The most common problems with Whirlpool washing machines are listed below, along with solutions.



1. The automatic washing machine shows an LD error code.

The error code "LD" is referred to a long drain. The water draining is taking too long, so the washer stops. Something blocking the pump or clogging the drain tube causes this error. Clear the pump filter of any lint or obstructions (such as a coin or tiny button).
Cut the water connections off. Unhook the washer's drain pipe at the back (keep a bucket handy to catch spills). Apply a long brush or a strong water spray to clean the line. If these measures don't resolve the issue, it may be necessary to replace the water pump.



2. The top-load washing machine lid is not locking.

It could be possible that the door latch or the door lock assembly is broken; hence, your washing machine lid is not locking. Please make sure they are intact. Also, check for damage to the door strike assembly. If the door strike is broken, you must replace it as it cannot be fixed.



3. Top-load whirlpool washer stopping in the middle of the cycle

This problem may cause due to loss of power, defective lid switch, or malfunctioned control board. Firstly, check whether a fuse or a circuit breaker has tripped if a washer stops in the middle of the cycle. Alternatively, the lid switch might have failed, causing the washer to halt mid-cycle.
A defective control board can also result in the washer stopping mid-cycle or restarting. If the control board is malfunctioning, the washer will frequently display an "F1" or "E2" error code. Control boards can be challenging to test with a multimeter and rarely fail. However, it can be examined for burn marks or circuit shorts.



4. The front-load washing machine is making a loud noise.

One of the most common problems with washing machines is making strange and loud noises. When that happens, you need to check for tub bearing.
The middle of the outer tub is where the tub bearing is installed. The inner tub spins smoothly with the help of the tub bearing. If it is damaged, it needs to be replaced. Replacing the tub bearing requires disassembling most parts of the washer, so we recommend seeking professional repair help here.



5. The washer does not spin.

The most common causes for the washer not spinning are loose drive pulley nuts, broken drive belts, and defective lid switch. As a safety measure, the lid switch prevents the washer from spinning when the lid is open. A multimeter should be used to test the lid switch to check for continuity. Next, check for the drive belt; by taking off the access panels, you can see the drive belt and make sure it's not damaged or worn out. Lastly, about the drive pulley nut, you will find it located on a drive pulley. Over time, nuts could loosen; hence remove the access panels and tighten the nut to get the washer into action again.



If you tried using the solutions listed above to get help and discovered that some of the parts require replacement, we are here to serve.
LetMeRepair provides the most fitting solution for all your washing machine problems with a 100% guarantee so that you can safely start running your machine. Our qualified technicians are experienced in fixing these appliances, and they can handle any issues that can arise with your Whirlpool washing machine. All types of washing machines in Bangalore can be repaired with just one call to LetMeRepair.

Visit our website for more details letmerepair.in.
washing machine repair in bangalore

Call us on
(+91) 96119 42942
or

contact now

Book Your Appoiment